Page 5
STORAGESTORAGE
STORAGESTORAGE
STORAGE
Follow the steps below to prepare your auger for storage.
Read your engine manual for detailed instructions on
preparing the engine for storage.
1. Run with gas stabilizer in fuel. Screen in carburetor will
glaze shut if gas stabilizer is not used before storage.
2. Drain the fuel tank. Run the engine until it stops.
3. Remove spark plug, pour one-half ounce of clean
engine oil into cylinder. Pull starter handle slowly
several times to distribute oil. Replace spark plug.
4. Clean entire auger.
5. Store your auger in a clean, dry building that is
inaccessible to children.
SERVICESERVICE
SERVICESERVICE
SERVICE
, TROUBLESHOO, TROUBLESHOO
, TROUBLESHOO, TROUBLESHOO
, TROUBLESHOO
TING ANDTING AND
TING ANDTING AND
TING AND
REPREP
REPREP
REP
AIRAIR
AIRAIR
AIR
SERVICE INFORMASERVICE INFORMA
SERVICE INFORMASERVICE INFORMA
SERVICE INFORMA
TIONTION
TIONTION
TION
At Ardisam, we build quality and durability into the
design of our products; but no amount of careful
design by us, and careful maintenance by you, can
guarantee a repair-free life for your auger. Most
repairs will be minor, and easily fixed by following the
suggestions in the troubleshooting guide in this section.
Do not store auger in an unventilated area where fuel
fumes may reach an open flame, spark or pilot light.
CAUTION
Drain fuel outdoors, away from any ignition sources.
Use only approved fuel containers. Be sure engine is
cool. Do not smoke.
CAUTION
MAKMAK
MAKMAK
MAK
OO
OO
O
, BARRACUD, BARRACUD
, BARRACUD, BARRACUD
, BARRACUD
A & BARRACUDA & BARRACUD
A & BARRACUDA & BARRACUD
A & BARRACUD
A PLA PL
A PLA PL
A PL
US INSTRUCTIONSUS INSTRUCTIONS
US INSTRUCTIONSUS INSTRUCTIONS
US INSTRUCTIONS
The guide will help you pinpoint the causes of common
problems and identify remedies.
For more complicated repairs, you may want to rely on
your retailer or an authorized mechanic (contact your
retailer for a list of authorized mechanics in your area). A
parts catalog is included in this section.
We will always be glad to answer any questions you have,
or help you find suitable assistance. To order parts or
inquire about warranty, call or write us at the address
found in the next column under the section ordering
repair parts or check out our website -
www.ardisam.com
ICE POINT REPLACEMENTICE POINT REPLACEMENT
ICE POINT REPLACEMENTICE POINT REPLACEMENT
ICE POINT REPLACEMENT
1. Remove both blades.
2. Remove nut and retaining bolt from point.
3. Using a locking pliers, grasp point and pull out. If holder
doesn’t come out with the point, remove with pliers.
4. With locking pliers, push in new point and holder aligning
bolt hole in point with holes in auger shaft. DO NOT
DAMAGE END OF POINT.
NOTE: When installing holder in auger shaft,
edges of holder may shave off.
5. Insert retaining bolt and tighten with nut.
IN CASE OF A SERVICE PROBLEM, DO NOT SEND
UNIT BACK TO RETAILER. CONTACT ARDISAM, INC.
AT 1-800-345-6007.
Auger blades and point are extremely sharp. Use
caution when removing & replacing.
CAUTION
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentarze do niniejszej Instrukcji